Klicken Sie hier für den Flyer

QSC RMX1450

Preis

Endstufe19"/2HE 18kg 2x 450W/4 Ohm

 

Specifications:

STEREO MODE (Both Channels Driven)
8 ohms
FTC 20 Hz - 20 kHz, 0.1% THD 260 W
EIA 1 kHz, 0.1% THD 280 W 
4 ohms
FTC 20 Hz - 20 kHz, 0.1% THD 400 W
EIA 1 kHz, 0.1% THD 300 W
2 ohms
EIA 1 kHz, 1% THD 430 W

 
BRIDGE MONO MODE
8 ohms
FTC 20 Hz - 20 kHz, 0.1% THD 530 W
EIA 1 kHz, 0.1% THD 600 W
4 ohms
EIA 1 kHz, 1% THD 830 W 
Signal to Noise, 20 Hz-20 kHz 100 dB
Distortion (SMPTE-IM) Less than 0.01% 
Input Sensitivity @ 8 ohms 1.15V (+3.4 dBu) 
Voltage Gain 31.6x (30 dB)
Output Circuitry AB 
Power Requirements 1/8 power pink noise at 4 ohms * 5A

 
Distortion (Typical)
20 Hz - 20 kHz: 10 dB below rated power  Less than 0.03% THD, 4 and 8 ohms  

1.0 kHz and below: full rated power Less than 0.03% THD, 4 and 8 ohms
Frequency Response 20 Hz-20 kHz, ±1 dB -3 dB points: 5 Hz - 50 kHz
Damping Factor, 1 kHz and below Greater than 300 at 8 ohms
Input Impedance 10k ohms unbalanced, 20k ohms balanced
Input Clipping 10 Vrms (+22 dB)
Cooling Continuously variable-speed fan, rear-to-front air flow
Connectors, each channel Input: Active balanced; barrier strip, XLR and jack(6.35mm)
                                                    Jack tip and XLR (pin 2 positive)
                                                     Output: touch-proof binding posts and Neutrik® Speakon®
Controls Front: AC switch, Ch. 1 and Ch. 2 gain knobs
               Rear: 10-position DIP switch
Indicators Power-On: Green LED
                 Signal: Yellow LED (1 per channel)
                 Clip: Red LED (1 per channel)
Amplifier Protection Stable into reactive or mismatched loads
Load Protection On/off muting, AC coupling (850, 1450), triac crowbar (1850HD, 2450, on each channel)
Power Requirements 100, 120, 230 VAC, 50-60 Hz
Dimensions 19" (48.3 cm) rack mounting, 3.5" (8.9 cm) tall (2 RU), 
                   15.9" (40 cm) deep (rack mounting to rear support ears)
Weight 15.9 kg

Bookmark and Share